Kc-hilites KC #341 4 LED Light System Instructions Manuel d'utilisateur télécharger pdf

Thanks for choosing a KC HiLiTES product. We take pride in building the highest quality, best

engineered systems possible. Your satisfaction with our product is important, so if you have any

questions, please call our customer service line at 800-528-0950. For warranty information, visit

our website at www.kchilites.com.

PLEASE NOTE - These lights are for OFF ROAD USE ONLY

PARTS INCLUDED

4 - LED Lights

1 - Wiring Harness Kit using

Raptor Auxiliary Switch

2 - Bracket Sets w/hardware

ASSEMBLING THE BRACKETS

1. Find the two driver side

b r a c k e t s m a r k e d “ A ” .

Assemble them using one of

the 1/4” bolt, nut and washers

as shown in photo1. Assemble the two passenger

side marked “B” as shown in photo 2. Attach two

lights to each set as shown in photos 1 & 2. (Ensure

the bend is down before mounting lights.)

MOUNTING THE BRACKETS WITH LIGHTS

1. Starting with the drivers side, remove the plastic

Christmas tree clip (photo 3). Find one of the small

plates with the nut welded to it. Insert it inside the

core tube and align the nut with the hole in the tube.

Slide the bracket assembly underneath the tab

where the Christmas tree clip goes. Align the ½”

hole with the hole in the core tube and the nut plate.

Insert the ½” bolt with lock washer through the

brackets and core tube and thread into nut plate.

Replace the Christmas tree clip, align the bracket

and lights, then tighten all hardware.

WIRING YOUR LIGHTS

1. The Ford F150 Raptor has four (4) auxiliary switches

on the center console. You will be using the switch

“Aux 4” (Relay #4) . This controls a fused 10 amp

Instructions for KC #341

4 LED Light System

w/Harness for Ford Raptor

Driver Side

Front

This side

bolts to core

support tube

1/4” bolt

through

both

pieces

Bend

is down

View From Above

View From Under Vehicle

Driver

Side

Front

Feed bolt through both

brackets and core

tube then thread into

nut plate inserted

inside core tube.

Photo 1

Photo 3

Passenger Side

Front

This side

bolts to core

support tube

1/4” bolt

through

both

pieces

Bend

is down

View From Above

Photo 2

Christmas

tree clip

Hole for

Christmas tree clip

Hole for

Christmas tree clip

Drivers Side Installed

- - Continue on reverse side - -

KC3265AU - 051613

Look may vary depending

on packaged purchased.

1 2

Résumé du contenu

Page 1 - 4 LED Light System

Thanks for choosing a KC HiLiTES product. We take pride in building the highest quality, best engineered systems possible. Your satisfaction with our

Page 2

circuit that is capable of handling the power required by the KC lights. F150 Raptor is also equipped with four (4) pass-through 12 gauge wires. These

Commentaires sur ces manuels

Pas de commentaire

Kc-hilites KC #341 4 LED Light System Instructions Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Kc-hilites KC #341 4 LED Light System Instructions. KC HiLiTES KC #341 4 LED Light System Instructions User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Kc-hilites KC #341 4 LED Light System Instructions