Kc-hilites KC #7307 Light Bracket for 1½, 1¾ or 2 inch Tubula Manuel d'utilisateur télécharger pdf

Thanks for choosing a KC HiLiTES product. We take pride in building the highest quality, best engineered systems possible.

Your satisfaction with our product is important, so if you have any questions, please call our customer service line at 800-

528-0950.

Parts Included:

1 - Light bracket (2 pieces) 4 - Allen (3/16” head) bolts ¼”-20 x 1½”

4 - Square nuts ¼”-20 4 - Washers ¼”

4 - Rubber spacers 2 ¾”x 2 5/16” x 1/8” 1 - Instructions

Installation

For 1½” Bar - You must use all four spacers. Cut ¼” off of the longer length

on two of the spacers. Set these aside. Remove the paper backing on the

two uncut spacers. Push one into each of the two halves of the bracket so

they do not overhang any of the edges. Now remove the paper from the two

cut spacers and put one in each of the two halves also allowing no

overhang.

For 1¾” Bar - You will only use two of the spacers. Remove paper and align

one in each half of the bracket as described above.

For 2” Bar - No spacers needed

Continue Installation

1. Fit both halves around the bar.

2. Slide a lock washer onto one of the bolts and insert it through one of the bottom

holes. Add a nut and tighten bolt only enough to hold nut in place.

3. Loosely add the other three bolts with washers and nuts.

4. Position and level the bracket to fit your needs. Tighten all bolts evenly by

Installation Instructions

KC 7307 Light Bracket for

1½, 1¾ or 2 inch Tubular Bar

KC HiLiTES, Inc. 2843 W. Avenida de Luces, Williams, Arizona 86046-0155 * 800-528-0950 * www.kchilites.com KC3266UW - 070909

e d

tails o

n o

r w

ebsite

ww.k

ilite

.co

23 Y

ear Wa

anty

Thanks for choosing a KC HiLiTES product. We take pride in building the highest quality, best engineered systems possible. Your satisfaction with our

Pas de commentaire

Kc-hilites KC #7307 Light Bracket for 1½, 1¾ or 2 inch Tubula Manuel d'utilisateur