Kc-hilites KC #517 Auxiliary Backup_Flood Kit Installation Manuel d'utilisateur télécharger pdf (Page 1)

Thank you for choosing KC HiLiTES for your vehicle. We take existing backup light circuit and when attaching the white

pride in building the highest quality, best engineered lighting wire.

systems possible. Your satisfaction with our products is

2. Determine where in the engine compartment you have a

important. So if there are any questions, please feel free to call

suitable 12 volt power source (battery or accessory terminal

our customer service line at 800-528-0950.

block). Remove the fuse and route the 25 ft. green wire from

the KC relay forward, using the shortest route and following

existing wires if possible to the power source. Attach the

TOOLS NEEDED .....

green wire to the 12 volt supply.

Drill motor 7/16" & 1/8" drill bits

3. Connect the white wire to the factory backup wire using the

12mm wrench Pliers

wire splice connector included with the kit.

17mm wrench Phillips screwdriver

4. Locate the red wire from the relay and plug it into the KC

backup light red wire furthest from the relay. Now run this

NOTE - THESE LIGHTS ARE NOT MEANT TO BE

red wire past the other backup light and attach the wire

SUBMERGED IN WATER

splice where you can easily plug in the second light.

5. The black wire on the KC light is to be attached to a good

MOUNTING INSTRUCTIONS .....

chassis ground. In most cases, if the lights are mounted on

1. The lights may be mounted anywhere at the rear of the

a metal bumper, the black wire can be attached right to the

vehicle provided they do not obstruct other lighting or

light mounting bolt. If they do not work with the ground wire

interfere with the exhaust.

attached this way, you may have to run the black wire back

2. If you have existing holes in the bumper, and they are

to some point on the frame.

located in an area that is practical for mounting, then use

6. All that's left is to replace the 20 amp fuse, adjust your lights

these holes. This will make your installation much faster by

to your particular needs and tighten them securely.

eliminating any necessary drilling.

3. If you do not have existing holes then you must drill two

- - - Wiring Option - - -

10mm holes (7/16" will also work) in an appropriate location

If you wish to switch your KC lights independently from your

under the bumper.

factory backup lights, you can purchase the KC 6303 add-on kit

4. Put one of the bolts up through the small slot in the bracket

and attach it as shown below.

and then up through the hole in the bumper securing it with a

lock washer and nut. Do the same with the other bracket.

5. Attach one of the lights to the under side of the bracket and

23 Year Warranty

position it as desired. Secure loosely with a washer and

See details on our website at

nut. Do the same with the other light.

www.kchilites.com

GETTING YOUR LIGHTS WIRED .....

1. Mount the relay at the rear of the vehicle within 6 feet of the

IF YOU HAVE ANY PROBLEMS OR QUESTIONS, PLEASE CALL

KC backup lights using an existing screw if possible.

CUSTOMER SERVICE AT 800-528-0950

(PLEASE ENSURE THE RELAY IS MOUNTED SO THE

TERMINALS ARE FACING DOWNWARD. THIS WILL

KEEP THE RELAY FROM RETAINING MOISTURE.) If no

existing screw is available, drill a 1/8" hole and use the

screw included. NOTE - In some cases the relay can be

mounted inside the taillight. This makes it easy to find your

Installation Instructions for

KC 517 Auxiliary Backup/Flood Kit

KC HiLiTES, Inc., 2843 West Avenida de Luces, PO Box 155, Williams, AZ 86046 * 800-528-0950 * www.kchilites.com KC 3269 - rev 072209

Diagram for KC 517 Backup/Flood and Optional KC 6303 Switch Kit Add-on

Supply

Load

Earth

LED

KC Switch

Brown

Wire

20 amp

fuse

Yellow Wire

Front of Vehicle

20 amp

fuse

Chassis

Ground

KC Backup Lights

Chassis

Ground

Chassis

Ground

RELAY

Add-on switch kit (KC 6303)

12 V Battery

901

Blue Wire

Green Wire

Red Wire

Wiring for KC 517

Attach to

factory backup

light wire.

White

Wire

Chassis

Ground

Black

Wire

Résumé du contenu

Page 1 - Installation Instructions for

Thank you for choosing KC HiLiTES for your vehicle. We take existing backup light circuit and when attaching the white pride in building the hig

Commentaires sur ces manuels

Pas de commentaire

Kc-hilites KC #517 Auxiliary Backup_Flood Kit Installation Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Kc-hilites KC #517 Auxiliary Backup_Flood Kit Installation. KC HiLiTES KC #517 Auxiliary Backup_Flood Kit Installation User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Kc-hilites KC #517 Auxiliary Backup_Flood Kit Installation Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Kc-hilites KC #517 Auxiliary Backup_Flood Kit Installation. KC HiLiTES KC #517 Auxiliary Backup_Flood Kit Installation User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Kc-hilites KC #517 Auxiliary Backup_Flood Kit Installation